Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-31-2004, 06:11 PM
|
#5 |
|
Registered Member
Join Date: Aug 2001
Location: Huntington NY
Posts: 573
|
You can pick up the wiring harness on ebay fairly cheap. I will be using a TEC3 engine managment system from Elecrotmotive for my 4v. It replaces all the factroy electrinics and allows you to run a supercharger without an FMU or a burned chip and will increase drivablilty and overall performance. Its only a few hundred more then a stock EEC and wiring with a burned chip and dyno tuning.
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New Engine Build Help | Young_Pony | Windsor Power | 2 | 08-22-2002 01:27 PM |
| build me an engine! | BLOCKER | Windsor Power | 5 | 09-17-2001 10:36 PM |
| Is the 4.6 Cobra engine found in any other Ford Product | Joel F | Small Ponies | 1 | 08-10-2001 04:58 PM |
| 2001 Cobra Over Rated AGAIN!!!?!?!!! Wassup Ford? | KillaZ350 | Blue Oval Lounge | 24 | 06-29-2001 05:24 PM |