

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
![]() |
#1 |
I'd rather be basketweaving
Join Date: Feb 2000
Location: Indianapolis
Posts: 2,551
|
![]() im guessing its a head gasket, as this is the same thing that happened to me
did you see the markings on the head gaskets that said "front" on them? if they're turned around, water wont be able to flow properly i know you said theres no coolant in the oil but it is sometimes hard to see, i couldnt tell by looking at the dipstick but i let the car sit then drained the oil to see about 1/2 gallon of pure coolant came out before ANY oil came out, i guess oil and water REALLY dont mix ![]() good luck with it ------------------ 88 Notch, B&M Ripper, 3.73's, Ported E7's, Explorer int. w/ ported lower, pulleys, 1.7RR's, BBK headers, off-road H-pipe, flowmasters, subframes, 65mm TB, March ram air ,MSD coil, U/L control arms, 155lph f/p, Crane Adj.FPR, Nitto drag radials, best 1/4--> 13.76@101.4 on a 2.17 60ft |
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Detonation + High Temp | richd | Windsor Power | 9 | 10-13-2001 02:15 AM |
Opinions on wheels(kinda long) | 1BAD89 | Windsor Power | 1 | 06-25-2001 07:05 PM |
Temp sensor question | RB92GT | Windsor Power | 2 | 06-23-2001 12:23 PM |
BBK one-piece flange or MAC individual flange long tube headers. | Fox Body | Windsor Power | 10 | 04-03-2001 04:25 PM |
billed 5 times to install clutch by Pauls Auto, please read and give opinions (long) | beefcake | Blue Oval Lounge | 2 | 02-23-2001 03:05 PM |