Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
04-23-2004, 02:35 PM
|
#1 |
|
Mustang Addict
Join Date: Jan 2001
Location: McKinney, TX
Posts: 1,294
|
It's a lot more than a few pounds. I took about 80 lbs off the nose of my car with tubular K-member, tubular A-arms, coilovers, brakes, and aluminum front swaybar (this is not just manufacturer's claims - the car is cornerweighted so I know exactly how much it weighs). Of course that stuff adds up to a lot more than $300 too.
__________________
Strike down the unroadworthy! 2000 GT Atl. Blue: '03 Cobra motor - 465rwhp/473rwtq, T-56 6-speed, full MM TA/PH & tubular K-member suspension, Saleen body, 17" Torq-Thrust II's, M/T ET Street radials, and lots more '94 Rio Red Cobra: All the bolt-ons, 3.73s |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Strut Brace 98 GT vs 96 Cobra | shelleysGT | Modular Madness | 4 | 01-16-2004 10:15 AM |
| Help! Strut Tower Brace - Will it fit w/this intake? | daveGT | Windsor Power | 5 | 08-05-2002 04:24 PM |
| caster/camber plates used with a strut tower brace | jtl | Windsor Power | 1 | 02-10-2002 10:31 PM |
| strut tower brace | BLK99GT | Modular Madness | 4 | 05-12-2000 06:14 PM |
| Strut tower brace install? | Ripper | Modular Madness | 1 | 03-28-2000 10:47 AM |