Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-05-2004, 12:28 AM
|
#5 |
|
Registered Member
Join Date: Sep 2002
Posts: 156
|
well the motor is already in the car... i had gt40 aluminums an b cam last season an was runnin 12.5's at 110+.. i called the edelbrock tech line an they said in order to run the vic. jr's u need at least 12:1 comp. an they recommended 600+ lift cam. so it sounds like i wouldnt see the full potential of thos heads an i dont wanna change cams again righ now. alos i forgot to add i'll be sparyin the car this year, but i just wanted to upgrade heads a lil.
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| block and head machining questions | bmxmon | Windsor Power | 6 | 09-26-2004 02:21 PM |
| After all normal bolt-ons... cylinder head questions | RED92LX50 | Windsor Power | 9 | 06-14-2003 08:43 AM |
| 351 head questions on my 5.0 | vetteeatr | Windsor Power | 0 | 08-28-2001 04:03 PM |
| Edelbrock Head Install Questions | Blaster | Windsor Power | 5 | 05-10-2001 12:22 PM |
| head gasket replacement stuff questions | fiveohpatrol | Windsor Power | 4 | 04-13-2001 04:23 PM |