Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-12-2004, 07:21 AM
|
#2 |
|
or '331 LX Eric'
Join Date: Jan 1999
Location: Columbus, Ohio
Posts: 2,142
|
Keeping the stock stroke of 3.00" you can bore the cylinders to:
.030" over to make a 306 cu in or .040" over to make a 308 cu in. I personnally haven't seen anything greater than a .040" over bore on a stock block. It may be possible, but I'm not sure who would make a piston for anything greater than 4.040". Plus, the more you bore the less material between the cylinders which means a weaker block. E
__________________
1991 5.0 LX Coupe - 40,750 miles 331 cu. in. / Tremec 3550 / BFG Drag Radials 12.22 @ 114.31 mph - w/1.89 60' |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Summer Plans | Stang_Girl617 | Blue Oval Lounge | 12 | 06-06-2004 02:22 AM |
| Axle from 4 banger work? | 90LxDroptop | Windsor Power | 1 | 04-01-2002 08:54 PM |
| Girl at work will not take NO for an answer! | Mercury | Blue Oval Lounge | 8 | 12-05-2001 11:43 AM |
| Supposed to run against guy at work. | Mercury | Stang Stories | 6 | 04-06-2001 10:58 PM |
| Need some professional advice - head work, valve springs, rockers, cam. pretty long. | AxemanZZ | Windsor Power | 15 | 01-11-2001 01:30 PM |