Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-12-2004, 08:29 AM
|
#4 |
|
Registered Member
Join Date: May 2001
Location: westerville, OH USA
Posts: 618
|
Well, since I didn't get any replies I went ahead and took some final measurements and sealed it all up. The backlash was around .60 and the carrier slide in pretty easily so everything should spin good and fast, the marking compound was slightly off but I think it'll work. Just kidding, I got the backlash to .008 and the carrier went it pretty snug. Other than figuring out how to use the proform pinion depth gauge and looking up specs the whole deal was definitely worth learning how to do and not having someone else do for a couple hundred $$$.
__________________
1990 Notchback: BBK Ceramic Coated Full length headers, Dr. Gas 3"- 2 1/2" x-pipe, Flowmaster 40's/turndowns. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Where to buy rearend rebuild kit? | AntwaanRandleEL | Windsor Power | 5 | 01-07-2003 11:19 PM |
| Rebuild Questions? | 5.0L_Of_Fury | Windsor Power | 5 | 12-29-2002 11:39 AM |
| 306 rebuild questions. | chris91LX | Windsor Power | 4 | 12-11-2002 07:30 PM |
| Rebuild Questions | Bobasaurus | Windsor Power | 0 | 05-27-2002 08:50 PM |
| advise on T-5 rebuild | 429mustang | Blue Oval Lounge | 0 | 07-23-2001 01:51 PM |