
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
#6 |
|
Registered Member
Join Date: Sep 2002
Location: cent.wis
Posts: 203
|
Thanks for ther great info, I'm going to order a new upper and lower intake in the next few days which one would you choose. I was thinking of the trickflow street for $350? I'm sure it flows much better than stock,but It also is about $100 cheaper than others. And for the extra 100 I don't think the others flow that much better. I'll also go with a 65-70mm tb. The only mods so far are k&n panel filter, timing 14deg,3.73,5spd,subs welded,1 5/8 shortys, mac off road X pipe, Mac cat-back,msd 6al,msd coil,8.5 msd wires. a/c delete,smog pump the trash, weld draglites,26x10.5 et streets. drive shaft loop. best so far 14.40@95 2.1 60ft. Any ideas pass them on. This winter maybe afr165's.
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Air by pass valve question. | Jaegermeister2k | Power Adders | 21 | 05-06-2005 09:40 PM |
| Valve cover question | Stang951 | Windsor Power | 1 | 03-27-2004 11:57 PM |
| EGR Valve Question. | Bobby L | Windsor Power | 1 | 08-22-2002 02:23 PM |
| master cylinder and prop valve question | shelby2 | Classic Mustangs | 1 | 07-05-2002 05:32 PM |
| EGR valve question? | 84LX89GT | Windsor Power | 3 | 09-07-2001 02:09 AM |
