MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Windsor Power
Register FAQ Members List Calendar

Notices


 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
Old 05-24-2004, 08:46 AM   #9
crazypete
Registered Member
 
crazypete's Avatar
 
Join Date: Sep 2002
Location: Boston
Posts: 592
Default

By "wont crank", do you mean it is not turning over or it wont kick in? I had an intermittent starting problem to the effect you descibed. It was nothing more than the main power terminal on the starter becoming corroded. It would crank sometimes, sometimes not. One day it stopped cranking altogether. I would never have found the problem if the starter wire had not started smoking!

For fuel pressure, just unbolt the regulator, place an inverted clear plastic cup over it, stand back and energize her! If it's a mighty spray, you've got pressure. If it's a little dribble, you dont. It's not very scientific, but it's free and convenient and lets you know if you are in the ballpark. As for the injector, unscrew a sparkplug, disconnect the coil wire and aim a flashlight into the cylinder and crank her. You will either see a little spray or smell it (or it will puff through the open plug hole). To diagnose a weak starting system due to bad ground or power, pull out _all_ the plugs and disconnect the coil wire. The engine will now offer no resistence to turning over (since there is no compression) . It will sound like a mingun and should tach at a constant rpm....like 400-500. If this works but it didnt work before, get some 80 grit and get down where the starter primary wire is, unbolt it, sand both the terminal and the wire connector and reattach. Do the same at the starter relay.

If all this fails, it's one of those silly modules, I had my TFI module go out on me a few years back for no apparent reason. I hate electronics, this is why I went carb (and I'm a programmer, I'm supposed to like computers).

Good luck!
__________________
91 GT Carb conversion, holley 600 double pumper, edelbrock performer intake, FMS "C" drop springs, march 1000 underdrive pullies, crane 1.7 roller rockers, GT-40P headers, bassani x pipe, american thunder catback, FMS 4.56's, msd aL6, trunkmount battery, A/C eliminator kit, 3000 stall tci streetfighter, AOD with transgo kit, A+ servo, 300M hardened lockup shaft, kevlar bands and 28,000 gvw trans cooler, 3 core radiator, 300 lbs stripped with a full interior
crazypete is offline   Reply With Quote
 



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Buy a U.S 1994 V8 5L GT Mustang in Australia (Imported from Japan)? fearby.com Windsor Power 8 09-10-2002 09:27 AM
Looking for a Mustang HighHeat Modular Madness 7 08-20-2002 06:07 PM
New Mustang Mustang[RIP] Classic Mustangs 2 10-17-2001 01:50 AM
Mustang Club of Central Iowa - Car Show, Swap Meet, Cruise & Autocross - June 2 and 3 KB1991 Ford Show & Go 0 05-31-2001 02:04 PM
Mustang Club of Central Iowa Autocross - May 6 - Marshalltown Go-Kart Track KB1991 Ford Show & Go 0 05-03-2001 12:33 PM


All times are GMT -5. The time now is 02:24 AM.


SEARCH