Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-26-2004, 12:08 PM
|
#11 |
|
Registered Member
Join Date: Aug 2001
Location: Huntington NY
Posts: 573
|
If the starter kept cranking then the soleniod stuck, most likely due to heat by drawing so much current. Its a $5 part, so replacing it shouldn't be a problem. When you get it to the shop, ask them to hook a scanner up to it, write down all the codes it gives you, and post them here.
I think your computer is alive since the fuel pump is working, so checking the fuses/relays shouldn't be neccesary. Have you checked the fuel pressure at the shrader valve? If so, what was it reading?
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Buy a U.S 1994 V8 5L GT Mustang in Australia (Imported from Japan)? | fearby.com | Windsor Power | 8 | 09-10-2002 09:27 AM |
| Looking for a Mustang | HighHeat | Modular Madness | 7 | 08-20-2002 06:07 PM |
| New Mustang | Mustang[RIP] | Classic Mustangs | 2 | 10-17-2001 01:50 AM |
| Mustang Club of Central Iowa - Car Show, Swap Meet, Cruise & Autocross - June 2 and 3 | KB1991 | Ford Show & Go | 0 | 05-31-2001 02:04 PM |
| Mustang Club of Central Iowa Autocross - May 6 - Marshalltown Go-Kart Track | KB1991 | Ford Show & Go | 0 | 05-03-2001 12:33 PM |