Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-29-2004, 06:18 AM
|
#4 |
|
Registered Member
Join Date: Mar 2004
Location: Long Island
Posts: 58
|
i switched push rods around w/ 3 different ones, and i changed the lifter on the valve too !! any other ideas ?
__________________
1990 Mustang GT Engine- 308 (bored .40 over) Probe Forged pistons (10.5:1), Scat forged crank and rods, w/Main Girdle, AFR 185 heads, GT-40 intake, CSI electric water pump. AC delete kit, No smog pump, Manual rack and pinion steering. Ignition- MSD 6AL, MSD Blaster coil, MSD hellicore wires. Drive Train- Tremic 3550, Alum. Drive shaft, 3:73 gears, Stock carrier and axels. 26X11.5 M/T Et streets. Power adder- 175 shot of laughing gas. Best ET 11.5 @120mph on squeeze, 12.4 @109mph on muscle (on gt40 heads) on the 185 heads ... ??? tba |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Built Motor? Questions | Rosco | Windsor Power | 1 | 10-22-2003 01:12 AM |
| Gt-40 motor timing problems? and smoke | drtbiker | Windsor Power | 0 | 09-22-2002 10:01 PM |
| Rebuilding an engine.. and then some | Halz | Windsor Power | 5 | 04-01-2002 02:01 AM |
| What year and type of motor do I have.. | Smokedawg | Windsor Power | 18 | 08-15-2001 05:08 PM |
| GT-40p headed motor | 89 Cobra LX | Windsor Power | 5 | 06-15-2001 06:46 PM |