Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|||||||
|
|
Thread Tools | Rate Thread | Display Modes |
06-18-2004, 12:08 AM
|
#10 |
|
YOU HAVE NO MARBLES!!!!!!
Join Date: Aug 2000
Location: Jonesboro,Georgia,USA (Providence, Ri)
Posts: 868
|
One more vote for 165's. The 185's would be too big for a stock 5.0.The 165's will make more average power than the TW's. We use either canfields or AFR's on all of our cars and have had great results with the AFR's. The canfields do great too, but need a lot of work to reach their full potential. Check out Brodix also. I will be switching to a set of their Neal heads on my new mill. I have 225's on my 408 and they make sick power, but on your 5.0 they will barely even run. Too much flow for such a small disp, small cam, and low rpm.
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| For whoever it was considering using stock ported heads | 2FastLX | Windsor Power | 5 | 10-11-2001 01:53 PM |
| Header bolt size | swtstang | Windsor Power | 1 | 05-22-2001 07:03 PM |
| is there any difference between 351C heads and 351M heads | tireburner163 | Windsor Power | 7 | 03-09-2001 09:26 PM |
| Is the true about Edelbrock heads with TFS intake? | gt93mustang | Windsor Power | 14 | 03-06-2001 07:01 PM |
| Head bolt size? help? | MAstang5O | Windsor Power | 1 | 02-07-2001 08:36 PM |