Roller conversion??

Fostang · 09-02-2001, 12:41 AM

I still can't decide what to do. I don't want to end up buying another block and having it checked for flaws and then it having one I would end up having to buy another. Plus the block I already have has been worked and is ready for new parts. 88 for 200 not bad considering that I was offered by a friend a 93' saleen it has 30 k miles on it. Complete even with headers and the the induction set up for $150. Too bad the car is too far. I could really use the rear end housing for the SVO. I think I'm going to think things over and probably am going to end up getting a roller block. thanks for the help guys.

------------------
67'fastback-Edelbrock carb,intake,cam,valve springs.Rhode lifters, CompCam rocker arms, windage tray,cerama coated headers,dual flows with H-pipe, modded c-4,tci stall converter,perma cool electric fan,aluminum water pump,griffen aluminum radiator,accel 8.8 cable,wide cap distriburator,magnetic pick up,v-matic hurst shifter,edelbrock performer nitrous, carter electric fuel pump,ignitor coil,solid motor mounts,magna racing suspension,poly urathane bushings,under rider traction bars, comp. eng. s

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Solid Roller ?	STROKER BILLY	Windsor Power	5	11-19-2002 12:04 AM
351W roller conversion	Capri306	Windsor Power	4	02-14-2002 04:49 PM
Crane roller conversion kit - Who's using it and what cam are you running?	2FastLX	Windsor Power	9	12-14-2001 04:09 PM
Non-Roller to Roller Block Conversion	Todd_A	Windsor Power	1	06-01-2001 11:01 AM
Roller Bearing Idler Arm Conversion	Dinosaw	Classic Mustangs	0	06-11-2000 07:12 PM

09-02-2001, 12:41 AM	#1
Fostang Registered Member Join Date: Feb 2001 Location: Stockton, Ca Posts: 599	I still can't decide what to do. I don't want to end up buying another block and having it checked for flaws and then it having one I would end up having to buy another. Plus the block I already have has been worked and is ready for new parts. 88 for 200 not bad considering that I was offered by a friend a 93' saleen it has 30 k miles on it. Complete even with headers and the the induction set up for $150. Too bad the car is too far. I could really use the rear end housing for the SVO. I think I'm going to think things over and probably am going to end up getting a roller block. thanks for the help guys. ------------------ 67'fastback-Edelbrock carb,intake,cam,valve springs.Rhode lifters, CompCam rocker arms, windage tray,cerama coated headers,dual flows with H-pipe, modded c-4,tci stall converter,perma cool electric fan,aluminum water pump,griffen aluminum radiator,accel 8.8 cable,wide cap distriburator,magnetic pick up,v-matic hurst shifter,edelbrock performer nitrous, carter electric fuel pump,ignitor coil,solid motor mounts,magna racing suspension,poly urathane bushings,under rider traction bars, comp. eng. s