AOD Shifting problems?

[dirtyd0g]

ok i'm going to try to explain how to adjust the tv pressure on this transmission here is a picture of the plug you will need to remove the pink one is the tv adjustment plug

you will need to put a transmission pressure guage in that hole

you will need a guage block that is .215 thick and slotted to fit over cable type cars (fuel injection)

on carb models you will install the guage block to hold the lever out that distance on cable models it's the same thing just slide it over the end of the cable holding the cable out that distance

pressure should be 33-35lbs idling warm in neutral with a idle less than 850

a 750 idle would work best at the 33lb setting a 850 idle at the 35 lb setting

if you have a 1000 rpm idle you will need to set it to about 38psi

and a 650 idle(good luck getting that) would need to set about 31-32