Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-08-2004, 12:07 AM
|
#1 |
|
Registered Member
Join Date: May 2004
Location: Mattoon IL.
Posts: 91
|
Changing Blocks
I Have a 65 289. I was wondering if the crank journal for the 289 and 302 were the same. Because I Have a Roller Block that I can put the crank and rods in if it will work. By roller block I mean already has the holes drilled and tapped for the lifter girdle. Also I have the heads for this block Which would be better the stock E7 heads or the C5 Heads that Were on the 289. Thanks any input would be great.
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Changing clutch | Just me | Windsor Power | 10 | 10-10-2003 01:45 PM |
| changing a rear end | ragtop5point0 | Windsor Power | 7 | 02-06-2003 01:37 PM |
| FMS 3:73 What else when changing? | homerojr | Windsor Power | 6 | 10-19-2001 05:45 PM |
| Aftermarket 4.6 Heads & Manifolds & Blocks...WHERE ARE THEY!! got any ideas? | Shawn | Modular Madness | 3 | 09-26-2000 02:07 PM |
| Changing ring & pinion gear is illegal | Ripper | Modular Madness | 1 | 04-06-2000 12:45 PM |