Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-02-2004, 09:27 AM
|
#8 |
|
Registered Member
Join Date: Oct 2002
Posts: 7
|
I finally got this sucker off and do see what you mean now. The gasket that was on there was a one piece and I bought a multi piece. Do you think that will make a difference? Or should I go get a one piece?
Also, the gaskets I bought are Felpro, are those good enough? And it says to use RTV black, will RTV blue be fine? And regarding the oil change, I did have to drain the oil anyway because of that. Are you recommending I fill it and then drain it again, just in case something did fall in there? Because when I was pulling the cover off, something may have fall in there. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Major Problem During Water Pump Install | Evil Joe | Windsor Power | 27 | 07-10-2003 03:45 AM |
| Water pump install... | Bad89stang | Windsor Power | 3 | 01-19-2003 10:59 AM |
| STEWART Water Pump issues :( ?? | LOBE_50 | Windsor Power | 6 | 05-15-2002 08:34 AM |
| Water pump....AC Bracket problem | Jimmy Page | Classic Mustangs | 3 | 07-28-2001 01:54 PM |
| Pulleys, water pump, and fan clutch | dinomite | Windsor Power | 5 | 05-26-2001 09:00 AM |