Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-14-2004, 10:26 AM
|
#2 |
|
Registered Member
Join Date: May 2002
Location: Tampa,FLORIDA
Posts: 340
|
I have had a similar problem before. It was my carb studs came loose. Also check/replace the carb to intake gasket.
If you are sucking air thru the base it could cause an overheat condition. Also check all the carb body bolts make shure everything is tight, they come loose sometimes.(remove carb for this there are some undertneath).
__________________
5.0, Holley heads, 1.7 Scorp Rockers, Stealth intake, Holley 600 carb, Holley Mech. Fuel pump, MSD 6Digital, MSD distributor, Hotchkis upper/lower rear control arms, FMS B Springs, 3:73 (8.8) rear. Production # 9,377 |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Can i put twin turbos and an intercooler on a carbed mustang??? | NotchStang59311 | Windsor Power | 3 | 04-14-2004 04:00 PM |
| Vin Diesel! | Shelby428cj | Blue Oval Lounge | 4 | 08-16-2002 01:32 PM |
| A couple stangs and a diesel truck | sedanman | Stang Stories | 7 | 06-06-2002 11:38 PM |
| E-303 Idles | Skyman | Windsor Power | 2 | 01-16-2002 04:51 PM |
| Propane Injected Diesel?? | Dark_5.0 | Windsor Power | 8 | 07-12-2001 03:42 PM |