Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
09-15-2004, 06:44 AM
|
#1 |
|
Rat Killer
Join Date: Aug 2002
Location: Cold ass Ohio
Posts: 1,143
|
It should slide right off. One thing to remember though, like I said each gear/ditsy is drilled after it's put together. This means that the hole in the new gear might not line up with the hole in the 84 ditsy. You can make it fit if you need to though, not a critical area of your engine swap.
__________________
d-Con Racing "Nothing fancy, just 347 inches of RAT POISON!" MICE need not apply..... 
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to remove belt tensionner pulley (picture inside) | White GT | Windsor Power | 5 | 06-18-2004 06:37 AM |
| remove hunk of metal near rear pumpkin? | Simi Stang | Windsor Power | 2 | 12-05-2002 06:27 PM |
| A/C Delete....Can I remove the condenser & the accumulator?? | MTU 50 | Windsor Power | 15 | 06-24-2001 12:26 AM |
| What type of screw to remove seatbelt? | Gautam | Blue Oval Lounge | 3 | 01-26-2001 04:48 PM |
| How to remove door panel in '89 5.0L? | Gautam | Windsor Power | 1 | 01-12-2001 03:14 PM |