Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-15-2004, 07:30 PM
|
#7 |
|
Registered Member
Join Date: Sep 2002
Location: Boston
Posts: 592
|
Any machine shop should do it. Cost me all of 20 bucks to have 1 pulled off and 1 pressed back on with the new pilot hole drilled.
Good Luck!
__________________
91 GT Carb conversion, holley 600 double pumper, edelbrock performer intake, FMS "C" drop springs, march 1000 underdrive pullies, crane 1.7 roller rockers, GT-40P headers, bassani x pipe, american thunder catback, FMS 4.56's, msd aL6, trunkmount battery, A/C eliminator kit, 3000 stall tci streetfighter, AOD with transgo kit, A+ servo, 300M hardened lockup shaft, kevlar bands and 28,000 gvw trans cooler, 3 core radiator, 300 lbs stripped with a full interior |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to remove belt tensionner pulley (picture inside) | White GT | Windsor Power | 5 | 06-18-2004 06:37 AM |
| remove hunk of metal near rear pumpkin? | Simi Stang | Windsor Power | 2 | 12-05-2002 06:27 PM |
| A/C Delete....Can I remove the condenser & the accumulator?? | MTU 50 | Windsor Power | 15 | 06-24-2001 12:26 AM |
| What type of screw to remove seatbelt? | Gautam | Blue Oval Lounge | 3 | 01-26-2001 04:48 PM |
| How to remove door panel in '89 5.0L? | Gautam | Windsor Power | 1 | 01-12-2001 03:14 PM |