Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-25-2004, 06:14 PM
|
#4 |
|
Registered Member
Join Date: May 2003
Location: So Cal.
Posts: 14
|
Suggestion.
Get the kit with flat top pistons. After the block is bored, mock it up to see how far down the pistons are. If .010/.015, have the block decked to bring to .000. Decking the block is a much better way to raise compression, compared to domes or head milling.
__________________
Some people can break a cannon ball, in a sandbox, with their bare hands. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| miling block part II....compression ratio? | Old Guy with 87 GT | Windsor Power | 11 | 02-13-2003 11:02 PM |
| decking block..questions | Old Guy with 87 GT | Windsor Power | 6 | 02-03-2003 08:59 PM |
| Head and intake questions and ideas | bad85gt | Windsor Power | 11 | 01-08-2003 07:06 AM |
| 86 block / E7 head question | 302man | Windsor Power | 5 | 11-13-2001 08:27 PM |
| Head questions | 88workcar | Racer's Club House | 2 | 06-25-2000 08:15 PM |