Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-07-2004, 12:02 PM
|
#4 |
|
Registered Member
Join Date: Jan 1999
Location: Farmingdale, NY
Posts: 139
|
...thanks fellas,
I actually went thru a can of STP carb & choke cleaner on the TB and a little on the IAC, although I didnt pull it out and cleaned it thoroughly since I replaced it last year (it should still be failry clean, right?? hmm...) . I'm still thinking about those BOSCH O2 sensors I payed for last year. I refuse to think they're already bad...but then again I do have a BBK pipe (w/ cats) and shorties. I'll look into the MAF too, and the PCV valve too... boy..gotta hate those cold starts!!!! thanks! fongo
__________________
1993 GT, MAC Fenderwell Cold Air Induction; Accel dist.,Splitfire plugs, BBK: 1 5/8 unequal length shorties, hi flow H-pipe w/ cats; Flowmasters 2 chamber American Thunder catback system, Motorsports 3-core radiator, 180º thermostat, BBK adj. clutch quad...the rest is bone stock!..but more mods to come!! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| warm start/idle stall, deceleration stall | mrrichard | Windsor Power | 1 | 08-13-2003 12:51 AM |
| Good Stall Speed? | Nixon1 | Windsor Power | 0 | 07-24-2003 12:25 PM |
| Launch Rpm Vs. Stall Speed | ciara | Windsor Power | 2 | 02-16-2003 10:20 AM |
| Anyone have advice on 393 stroker camshafts & stall speed? | Stang_ROTY | Windsor Power | 4 | 04-11-2002 03:34 PM |
| Dont 99+ GT's have Alunimum drive shafts? | Mercury | Modular Madness | 5 | 05-15-2001 12:33 PM |