Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-21-2004, 07:26 PM
|
#16 |
|
Registered Member
Join Date: Sep 2002
Location: Boston
Posts: 592
|
Re: Carb has too much idle hole drilled?
AHA!
I did the intake test and I got a flickering 0-1 psi(?). There is one and only one vacuum stem and that had the guage on it (slid onto a hose with a clamp) so I guess it is the intake. It must be an intenal leak because I rtv'ed around the intake top earlier and rtv'ed the carb base so it was not leaking from there either. The carb was fully closed. As long as I will be pulling the intake, I'll heli-coil that annoying stripped thread. Well, at least I know I did the head/intake port correctly and the rockers were a good purchase. That low cylinder pressure still bugs me but well let the "seat of the pants" decide how this project turned out.
__________________
91 GT Carb conversion, holley 600 double pumper, edelbrock performer intake, FMS "C" drop springs, march 1000 underdrive pullies, crane 1.7 roller rockers, GT-40P headers, bassani x pipe, american thunder catback, FMS 4.56's, msd aL6, trunkmount battery, A/C eliminator kit, 3000 stall tci streetfighter, AOD with transgo kit, A+ servo, 300M hardened lockup shaft, kevlar bands and 28,000 gvw trans cooler, 3 core radiator, 300 lbs stripped with a full interior Last edited by crazypete; 10-22-2004 at 07:21 AM.. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| not your everyday carb problem | hobgoblin351 | Classic Mustangs | 8 | 11-04-2003 01:13 PM |
| Adjusting Length of high idle on Carb 5.0 | twilightcall | Windsor Power | 8 | 08-06-2003 08:31 AM |
| to carb, or not to carb...this is my question. | black86notch | Windsor Power | 4 | 08-06-2002 08:24 PM |
| new carb..but how much cfm?? | 69PonyRider | Classic Mustangs | 4 | 09-13-2001 07:59 AM |
| demon carb on 289??? | 69roadrunner | Modular Madness | 1 | 07-21-2001 07:42 PM |