Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-30-2004, 09:47 PM
|
#3 |
|
Registered Member
Join Date: Mar 2004
Location: Minnesota
Posts: 950
|
Re: engine building questions
Where do i get a ring trimmer at?? When i measured my top ring end gap, (one of them) it measured at .018. My pistons say to use 20-40% more than stock. Im guessing with my oil ring i just measure the two small rings, and leave the zig zaged ring alone, right? Just want to make sure. thanks
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Classic Mustangs | 8 | 06-16-2005 11:43 AM |
| Just got a 98, have some questions? | 98GTNewbie | Modular Madness | 5 | 08-30-2003 12:41 AM |
| raced a Supra Twin Turbo | Stang35th | Stang Stories | 63 | 08-23-2003 12:36 AM |
| Desk top dyno 2000,any body ever"check" with real dyno pull after building engine? | robertwigton | Windsor Power | 8 | 12-01-2001 03:03 PM |
| Engine swap: | boeing727 | Built Ford Tough | 1 | 11-20-2001 10:38 PM |