Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
11-11-2004, 10:55 PM
|
#1 |
|
Import Slayer
Join Date: May 1999
Posts: 2,241
|
Re: engine building questions
My best advise to you would be to buy a book on rebuilding small block Ford engines. It will provide all the clearances and specs needed to build your engine.
BTW, I think the cam shaft endplay clearance should be .005in.
__________________
'82 GT 351W (.060)Comp Cams 274* Extreme Energy cam, ported & polished heads w/ 1.94/1.60 valves 10.3:1 flat top pistons,stealth intake, Mallory dizzy,Holley 750dp carb, BBK shorties,Flowmaster exhaust,C-4 with 3700 stall converter, B&M pro shifter,8.8 rear, 4:10's, subframes, electric fan, powermaster alternator, 4 core radiator. |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Classic Mustangs | 8 | 06-16-2005 11:43 AM |
| Just got a 98, have some questions? | 98GTNewbie | Modular Madness | 5 | 08-30-2003 12:41 AM |
| raced a Supra Twin Turbo | Stang35th | Stang Stories | 63 | 08-23-2003 12:36 AM |
| Desk top dyno 2000,any body ever"check" with real dyno pull after building engine? | robertwigton | Windsor Power | 8 | 12-01-2001 03:03 PM |
| Engine swap: | boeing727 | Built Ford Tough | 1 | 11-20-2001 10:38 PM |