Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-18-2004, 07:59 AM
|
#7 |
|
Rat Killer
Join Date: Aug 2002
Location: Cold ass Ohio
Posts: 1,143
|
Re: fender removal?
Dark 5.0 is right, WAY easier to take off the whole front clip. Fenders bolt to the frame in the door jambs (mark where these are before you unbolt them for reassembly line up), there's a brace in front of the wheels, unplug the wiring harnesses for the headlight/parking lights. It's been a while since I've done it, but I BELIEVE the front facia is bolted on to the header panel, and possibly a couple rivets. There are also a few small bolts on the bottom side of the nose. Take all that stuff loose, and then see what's still holding you up. Not a bad job at all, and reassembly is a breeze, almost nothing to line up!
__________________
d-Con Racing "Nothing fancy, just 347 inches of RAT POISON!" MICE need not apply..... 
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Front Fender Rub, help! | TMASTER | Windsor Power | 3 | 12-23-2002 02:37 AM |
| are 92 and 93 fender wells bigger like the fender? | fantozi | Windsor Power | 1 | 09-28-2001 11:56 PM |
| Rolled fender lips? | autoX | Windsor Power | 8 | 06-27-2001 04:00 PM |
| '87-'90 inner fender vs. '91-93' Inner fender | RMARIANI | Windsor Power | 9 | 06-23-2001 08:09 PM |
| fender removal | Dino | Modular Madness | 0 | 11-24-1999 10:33 PM |