Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-08-2001, 07:04 PM
|
#3 |
|
Mustangs
Join Date: Jul 2000
Posts: 1,938
|
go to www.extrudehone.com and request a brochure. I ordered one and in the brochure it says that they flow match all the runners (apparently #'s 1 and 5 flow less than the others) and i think it increases flow to over 50% more than stock. Definately worth looking at even though it'd cost about $500. If you can do this at home, i believe that you can really extensively port them if you have the right tools.
If you open up the systemax lower and match the upper to it, i'm sure you could make ALOT of power. Hell, even if you port the sh/t out of the upper and make a mistake you could probably find another used one for under $50. Good luck, ------------------ previous name: 84stangLX '84 Mustang 5.0 LX my LX '89 Mustang GT my GT |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 351W EFI Long Runner Intake under STOCK hood | 89fast5oh | Windsor Power | 2 | 03-23-2025 05:08 PM |
| Port match stock intake? | skiwesser | Windsor Power | 3 | 11-21-2002 02:09 AM |
| What's the fastest a MAF EFI 5.0 can run with BONE STOCK HEADS, CAM, AND INTAKE? | gtsr515 | Windsor Power | 6 | 05-26-2002 05:06 PM |
| TFS intake and stock throttle body?? | DemonGT | Windsor Power | 2 | 05-23-2001 01:19 PM |
| Stock intake manifold | 89LXNB | Windsor Power | 16 | 01-09-2001 07:14 PM |