Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
09-08-2001, 11:47 PM
|
#1 |
|
Registered Member
Join Date: Apr 2000
Location: middleburg, fl, usa
Posts: 1,134
|
Hey unit, I saw an ad like that and they tested several intakes before and after extrude honing and the stock did flow a little less but had the best runner balance of all the intakes tested. You can port extensively by cutting the intake and if you want to do like mine on my old mustang you can open it up so much in the front that you will have to weld the hole where the bolt goes through in the center. That is a big restriction. If I had to do it all over again I would have done it the same but I would have also had it extrude honed to make it perfect.
------------------ James Cox nochevy@hotmail.com 1991 Mustang LX No times with 347 stroker yet. |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 351W EFI Long Runner Intake under STOCK hood | 89fast5oh | Windsor Power | 2 | 03-23-2025 05:08 PM |
| Port match stock intake? | skiwesser | Windsor Power | 3 | 11-21-2002 02:09 AM |
| What's the fastest a MAF EFI 5.0 can run with BONE STOCK HEADS, CAM, AND INTAKE? | gtsr515 | Windsor Power | 6 | 05-26-2002 05:06 PM |
| TFS intake and stock throttle body?? | DemonGT | Windsor Power | 2 | 05-23-2001 01:19 PM |
| Stock intake manifold | 89LXNB | Windsor Power | 16 | 01-09-2001 07:14 PM |