Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-25-2001, 03:57 PM
|
#3 |
|
Registered Member
Join Date: Sep 2000
Location: Fresno,CA. USA
Posts: 384
|
I'm not sure if i follow you but when i did mine i just popped it in.
i put the old one over it and tapped it w/ a mallet. Look good at the old one b4 you yank it out. ------------------ 4.10's,long tubes & 75 shot...Goes 12.50's Check it out at http://www.burnouts.webprovider.com |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need quick reply.... C/C plate install | DZEE'S LX | Windsor Power | 1 | 04-06-2002 08:54 PM |
| Help! Quick question about rear end | Niks90coupe | Windsor Power | 3 | 09-16-2001 12:43 AM |
| Any tips on rear assembly/lower cntrl arm install? | LOCASH | Windsor Power | 1 | 04-30-2001 04:35 AM |
| Rear main seal ....(semi-long) | Shotgun28 | Windsor Power | 1 | 03-13-2001 02:04 PM |
| 9inch rear end install | glxstang | Windsor Power | 3 | 02-05-2001 10:24 AM |