

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
![]() |
#1 |
Registered Member
Join Date: Jun 2004
Location: British Columbia, Canada
Posts: 25
|
![]() but now it won't even start at all...it tries too..but it just doesn't seem to work...
it turns over and cranks...but doesn't start up.. i have NO idea... is it my computer?? perhaps? thanks! Erik... |
![]() |
![]() |
![]() |
#2 |
Rat Killer
Join Date: Aug 2002
Location: Cold ass Ohio
Posts: 1,143
|
![]() Get your fuel pump issue taken care of first. Then change the ignition module (TFI) on your distributor like Pkrwd said. Make sure you coat the back of the new one GOOD with the supplied white "grease", those things don't like heat at all.
__________________
d-Con Racing "Nothing fancy, just 347 inches of RAT POISON!" MICE need not apply..... ![]() |
![]() |
![]() |
![]() |
#3 |
Registered Member
Join Date: Apr 1999
Location: Cincinnati,OH
Posts: 1,511
|
![]() Alright man this may not be your problem but something to think about. A few years back I was having the same problem as you. It turned out to be a wire at the starter relay was broken at the connector. It looked like everything was fine but the wire was broken. I had spark at the plugs, the car would turn over..but the fuel pump wouldn't turn on. So I hard-wired the fuel pump and it still wouldn't start. So I started chasing wires. And that's what I found. I can't remember what exactly the wire does now. But I know that it sends a signal to the EEC. And that goes to the fuel pump. What's weird is that even with the fuel but running it still wouldn't start. Gotta love computers. I know there's also some fusable links in that wiring too so you might want to check those out. I did all the wire shooting with a haynes manual. Hope this helps man! Good luck.
-Ryan
__________________
89GT,Pro-Bullet 306, H/C/I and a bunch of other stuff. *Sold* 00GT, Vortech S-Trim, Steeda Boost Pipe, C&L intake, Mac off-road H-pipe, Flowmasters, B&M Ripper shifter, Eibach Sportline springs, Koni Struts/shocks, MM full length subframe connectors, Cobra brakes, 3.73's. My Car Domain Page |
![]() |
![]() |
![]() |
#4 |
Registered Member
Join Date: Jun 2004
Location: British Columbia, Canada
Posts: 25
|
![]() I checked.....nothing..
i have NO idea why it won't start.... DAMN!!! this is soo frustrating ![]() ![]() |
![]() |
![]() |
![]() |
#5 |
2 Stangs in the Stable
Join Date: Apr 2002
Location: Baytown, TX
Posts: 1,209
|
![]() Listen to PKRWUD, he knows his stuff. Take the TFI module off and take it to your local parts store. They should be able to test it for you and it shouldnt cost you anything. If its bad, replace it. They're not that expensive, but can wreak havoc on your frustration levels. And they are notorious for going bad. There was a recall on them for certain years from Ford.
__________________
'90 GT Under construction Best E.T. = Fast @ High Speeds - OK So I Lie. So What!!! ![]() ![]() 04 F-150 STX 4.2L 5 spd Rice Haters Club Member #128 |
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wont Start, help! 1995 GT 5.0 | Year2001Boogie | Windsor Power | 13 | 05-05-2004 09:26 PM |
Wont Start, Dies, Help ! 1995 GT-5.0 | Year2001Boogie | Modular Madness | 8 | 04-29-2004 02:12 PM |
EEC does not energize unless key turned to start | crazypete | Windsor Power | 23 | 09-20-2002 09:00 AM |
sometimes car turns over a lot but doesn't start | MineralGray02K | Modular Madness | 3 | 09-16-2002 10:41 PM |
Car won't start with key | 92Rustang | Windsor Power | 5 | 12-01-2001 01:10 PM |