Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-11-2005, 05:10 PM
|
#3 |
|
Registered Member
Join Date: Feb 2002
Location: Maryville,TN
Posts: 415
|
Re: Pi Intake Problems!!
The PI intake fits fine on the NPI motor. Usde the NPI gaskets and use a good bead of gasket sealant along the inside legnth of the gasket. Also use a good bead around the coolant ports. The temp sensor can be put in the flat section near the termostat. It needs to be drilled and tapped, can't remember the exact size. This mod added 20 rwhp, all over 3K rpms. I have had it for well over two tears with no leaks. I remeber being one of the first dozen or so guys doing this mod when everyone on this forum and the othe big # forums were saying " It won't work, It wont fit, It will Leak" buch of BS. It works great. Do the PI cam swap next and you will be very happy!!
__________________
98 GT / convertable -98 Saleen engine, Saleen appearance pkg. SHM cams,P&P NPI heads, and so much more! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New Intake with NITROUS!!!???? | NOSstang08690 | Power Adders | 9 | 09-09-2003 07:05 AM |
| Head and intake flow. Something to think about. :) | 5ohCOUPE | Windsor Power | 3 | 03-16-2003 08:52 AM |
| 4.6L Intake spacer!!!! | skz4u | Modular Madness | 18 | 01-27-2003 11:11 PM |
| Edelbrock spec's and intake question?? | jerryIII | Windsor Power | 0 | 05-24-2001 12:49 PM |
| FYI-4.6 intake problems | PKRWUD | Modular Madness | 6 | 02-01-2000 02:26 PM |