Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-02-2005, 09:31 AM
|
#4 |
|
Gimme a Drink!
Join Date: Dec 2002
Location: NYC
Posts: 694
|
Re: Aftermarket Gauge Install?
you cannot use the stock sender w/ autometer gauges, you simply take out the old senders, pop in new ones with teflon (no leaks) and run the wiring as per their instructions. you only need a t fitting if you want to run BOTH the autometer and stock gauges. post any other ques, good luck
__________________
1990 GT,stock T-5,K&N w/o air silencer,March underdrives,FMS wires,timing@14*,PA Perf 130amp alt,Steeda Tri-Ax Shifter,Steeda adj quadrant/clutch cable/firewall adj,Centerforce II clutch,o/r x-pipe,Magnaflow SS catback,g-load brace, subframes,Bilstein struts/shocks,Autometer gauges, 136k and running strong! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| fuel gauge install | GhettoPop | Windsor Power | 4 | 01-23-2004 01:41 PM |
| How do I install an Autometer gauge | Kamaro Killer | Windsor Power | 1 | 09-16-2002 06:36 PM |
| Fuel Gauge install questions | Chipdog | Windsor Power | 0 | 08-12-2001 07:06 PM |
| Oil pressure gauge install | mustangLX92 | Windsor Power | 1 | 07-19-2001 09:12 PM |
| Gauge Install Questions | RB92GT | Windsor Power | 3 | 06-09-2001 03:07 PM |