Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-29-2005, 10:40 PM
|
#2 |
|
Registered Member
Join Date: Jun 2001
Location: butler pa
Posts: 303
|
Re: Rear Contol Arm Bushings
i took a drill and ground out most of the rubber till the bushing fell out and i did the axle while it was in place on jackstands just take your time and you should be fine id also figure on cleaning the holes out with a wire wheel i used one that fit right in the same drill i used to run out the rubber
__________________
92lx wannabe saleen |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| new rear end | fordkid68 | Classic Mustangs | 18 | 11-24-2009 08:05 PM |
| want rear disk without changing overall length of rear....please help!!! | dragstang86 | Windsor Power | 1 | 07-31-2003 06:32 PM |
| cobra rear questions | dragstang86 | Windsor Power | 3 | 07-02-2003 06:56 PM |
| Rear Polyurethane Bushings | TMASTER | Windsor Power | 4 | 11-06-2002 11:52 PM |
| Rear Brake Line Removal | Kisner | Classic Mustangs | 2 | 03-13-2002 12:31 PM |