Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-08-2005, 11:45 AM
|
#9 |
|
Registered Member
Join Date: Mar 2004
Location: Minnesota
Posts: 950
|
Re: header help!!!
I cannot get these things to bend! I dented them though.... Any other advice?? I can get enough pressure out of the pry bar, because my brother and i are holding the header, so its not very solid. Also, does anybody know how far the clutch fork moves back and forth?? That is the main obstacle. Thanks.
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Broken Header Stud (header to Hpipe) | PeTr0 | Windsor Power | 3 | 01-01-2005 06:34 PM |
| 1 3/4 long tube header install. | Dark_5.0 | Windsor Power | 1 | 08-05-2004 01:51 PM |
| Header and Exhaust Installation | 1991GT | Windsor Power | 4 | 12-03-2002 11:17 PM |
| Whats the going price for long tube header installation? | Dark_5.0 | Modular Madness | 3 | 09-19-2002 03:29 PM |
| Header Gasket Help Needed | Phillip Long | Windsor Power | 5 | 05-03-2002 01:59 PM |