

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#7 |
Registered Member
Join Date: May 2005
Location: York, PA
Posts: 46
|
![]() TPS is your throttle postion sensor. its the little guy on top of you throttle body. One wire is ground, one is 5v refernece wire from the computer and the other is the signal wire back to the computer. at idle you are probably looking for anywhere from .8 to 1 volt and a WOT around 4.5 or more volts. do not try to check voltage at WOT with the engine running. It can be done with the key on.
__________________
1990 Notch, 306, T-56 trans, 3:73 gears, zex 100 shot, gt-40,z-303 cam, roush 200 heads, powerdyne on the way |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Adjusting Length of high idle on Carb 5.0 | twilightcall | Windsor Power | 8 | 08-06-2003 08:31 AM |
Low, loppy idle then too high, then low again.... | Fox Body | Windsor Power | 6 | 08-05-2003 11:29 PM |
high rise manifold | fordkid68 | Classic Mustangs | 2 | 05-18-2003 01:38 AM |
306 street fighter from Coast High. short-block | yelowjaket | Windsor Power | 2 | 05-15-2003 06:02 PM |
High Reving Upon Startup | D&R Stang | Windsor Power | 8 | 06-03-2001 11:43 AM |