Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-16-2005, 05:52 PM
|
#9 |
|
Registered Member
Join Date: Nov 2000
Location: Maple Ridge B.C. Canada, The Best Place In The World
Posts: 871
|
Re: Problems With SN95 5.0L.... Please Help
i checked fuel pressure today, at an idle it sits at about 30 or so, but if i give it any gas, it jumps up(didnt see it hit 40psi though, which is what i thought they were supposed to sit at).
when i just turn the key on without starting the truck, it jumps up almost to 35, then slowly drops, but fast eanough you can watch it dop down. what could this be? could it be the source of some of my problems? i ran the motor, and reved it a little and POP from the intake, like a manifold backfire from a carburated engine. i pulled various spark plug wires while it was running and noticed little to no change in the way it ran, which has me really stumped. does this sound like my timing?
__________________
1984 Bronco II, 36" Michelin Military Tires, 95 EFI 5.0, NP435 Tranny, NP208 Doubler, NP205 Transfer Case, Fill Size Solid Dana 44 Front End, WH Progressive Rate Rock Crawling Coils, Bronco 8.8 Rear, Skyjacker Softride Leafs, 5.13 Gears, Detroit Locker. Final Crawl Ratio Of 175:1 88 GT Best 60ft. 2.181 Best ET 14.350 Best MPH 98.01 ~WRECKED!!!!~ Last edited by BowTie Eater 5 Liter; 06-16-2005 at 06:34 PM.. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| what if any problems with your Modular Model Gt/Cobra? | fixer | Modular Madness | 18 | 04-03-2005 09:18 AM |
| HELP: Problems after Paxton Novi 1000 install | Meatman | Windsor Power | 3 | 10-17-2002 06:03 PM |
| '65 - Pull Away Problems - Action Plan | geordie | Classic Mustangs | 0 | 05-14-2002 01:43 PM |
| Need guage pod for SN95!! | blueneonman1 | Windsor Power | 2 | 07-16-2001 10:43 AM |
| does gt40 intake work with sn95? | daz95gt | Windsor Power | 8 | 01-13-2001 08:20 AM |