Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-13-2005, 06:23 PM
|
#3 |
|
Registered Member
Join Date: May 2002
Location: Long Island, NY
Posts: 14
|
Re: rocker adjustment
im aware of that method. (top dead center method) and also eoic, when exhaust opens adjust the intake and when the intake is closing adjust the exhaust. Used when radical cams are used to ensure heel of cam lobe. Thats all well and good. but with stock pedestal mount valvetrain it seems as though as much as you tighten the rocker it cannot preload the lifter any further since it is sitting on its pedestal. How could it move down further. Or on the other hand, tightening till the pushrod stops moving could leave the rocker raised, not on the pedestal......Would this be ok. I dont think it would be. Your advice works perfectly on stud mount rockers.
__________________
306 Short Block, Forged Pistons, GT-40 Irons, Ford Racing 1.6 Ratio Rockers, GT-40 Upper and Lower Intake, B-303 Cam, 24 lb Injectors, 70 MM Throttle Body, 75 mm MAF, MAC Cold Air Intake(in fender), March Ram Air Scoop, MAC Longtubes, Offroad H-Pipe 2.5", No Cats, 40 Series Flows, 2.73's(eek...), Kenny Brown Subframes, World Class T-5, Pro 5-0 Tower Shifter |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rocker adjustment | zach0 | Classic Mustangs | 3 | 04-24-2004 12:28 PM |
| Rocker arm re-adjustment | Prochrgd1 | Windsor Power | 1 | 04-14-2002 03:32 PM |
| Power loss due to bad RR adjustment? | gt93mustang | Windsor Power | 0 | 03-19-2001 01:17 PM |
| Rocker Arm Adjustment | bcinyuz | Windsor Power | 1 | 02-27-2001 02:05 AM |
| roller rocker adjustment | gray87GT | Windsor Power | 1 | 02-06-2001 01:14 PM |