Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-22-2005, 10:26 AM
|
#7 |
|
Registered Member
Join Date: Jun 2002
Location: manassas, va
Posts: 186
|
Re: Starting Problem
Now, if it begins to start while cranking and then doesnt after you release the key from the starting position, i would bet dollars to donuts its your ballast resistor. During cranking, your coil will recieve full power, but after starting, the circuit switches over and power is reduced by going threw the ballast resistor. A quick check is to bypass the ballast resistor with jumpers and see if it starts and runs.
__________________
1983 mustang, 393 cubic inch stroker small block, victor jr heads and intake, gold race 1.6 roller rockers. comp cam 304, 244@ .050. .576" hydralic retro roller cam,lunati rods. block was o-ringed,10:1 forged pistons, speed pro fit fit rings, clevite bearings,msd distributor and igniton,be cool huge radiator, black lite electric fan, march underdrive pulleys, mildon deep sump oil pan, mac 1 3.4" long tube headers, 3" dr gas x-pipe and mac exhaust,ARP bolts. car weighs 2900 lbs w/out driver, sub frames, weld wheels, mickey thompson sportsman pro 26 x 10.5 x 15's,#8 fuel line steel braided |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 99 mustang starting problem | lary22 | Modular Madness | 0 | 02-05-2003 03:25 AM |
| Intermittent starting problem | Hethj7 | Windsor Power | 0 | 10-01-2002 01:12 PM |
| Please Help !! Engine Starting Problem | Jayskee | Windsor Power | 1 | 07-23-2002 06:08 PM |
| Starting problem | Kdogg | Small Ponies | 8 | 05-22-2002 07:29 PM |
| Need help with starting problem.... | Godslayer | Windsor Power | 4 | 01-10-2002 01:59 PM |