Has anyone put turbo(s) on an 87-93 mustang?

silver_pilate · 09-21-2001, 11:37 AM

88GT,

There are a couple of guys on this board and a few more on the Corral running Incon Twin Turbo setups. I looked pretty closely at them a while back when I was thinking of TT, and they have a good reputation and a good product.

The Incon kit comes complete with everything you need including injectors, fuel pump, tubos, brackets, intercooler, and even spark plug wires. You're probably going to have to pull the motor for the install because you have to notch a panel in the engine compartment, but that's no biggie.

Bob Cosby ran Incons on his daily driver mustang notch with just a few bolt-ons and engine mods. Here's a quote from his page:

"Last summer I installed one of the awesome INCON Twin Turbo kits. This is a very well thought-out and complete Street Turbo Kit. I did nearly the entire project by myself, in my garage, with no special tools. The full story is here. It is perfectly streetable, and saw about about 300 miles per week, including an 11 day, 4000 mile plus trip to race at the World Ford Challenge, Texas, and more - pulling a trailer!. How did it run? Last September, on a warm and muggy night at Va Motorsports park, it turned 11.00 @ 124.17 mph. Stock ported heads/intake, driven to and from the track. Not bad! With some better heads and intake, along with a bullet-proof AOD, it ran 10.92 @ 126 mph on ET Streets and through the mufflers. That was with a very lazy 1.68 60 ft."

Oh, and he averaged around 24mpg on the highway.

Here's his page:
http://members.home.net/bobcosby/stang/

TDC (Turbo Driven Concepts) makes some other kits...and I know there are a couple of other manufacturers out there but they escape me for now.

--nathan

------------------
--silver_pilate

'91 GT, Built 306, Wolverine 1087 cam, ported Windsor Jr. Irons, and all the goodies...click the link to the left to see a full list of my mods...

Tried and True 302 Being Built to Outrun You! heh heh heh...
--Texas Panhandle--
Check out my site

[This message has been edited by silver_pilate (edited 09-21-2001).]

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Safety Issue 64 - 70 Mustangs	Mach1 Cobra Jet	Classic Mustangs	20	07-11-2005 08:06 PM
Yellow Mustang Stampede TULSA OK August 17	stylin99	Ford Show & Go	2	11-09-2004 11:19 PM
t-5, is it the same in the 4 cylinder and V8	ex-lt1-guy	Windsor Power	12	03-03-2002 01:59 AM
89-Mustang pulling trailer -vs- 2000 Mustang	Five0	Stang Stories	7	04-01-2001 02:50 AM
Salaeen, Shelby, Cobra please define these for me.	Taqus	Blue Oval Lounge	3	01-17-2001 02:39 AM

09-21-2001, 11:37 AM	#2
silver_pilate DURKA DURKA!! Join Date: Sep 1997 Location: Lubbock, TX...(TX panhandle) Posts: 1,418	88GT, There are a couple of guys on this board and a few more on the Corral running Incon Twin Turbo setups. I looked pretty closely at them a while back when I was thinking of TT, and they have a good reputation and a good product. The Incon kit comes complete with everything you need including injectors, fuel pump, tubos, brackets, intercooler, and even spark plug wires. You're probably going to have to pull the motor for the install because you have to notch a panel in the engine compartment, but that's no biggie. Bob Cosby ran Incons on his daily driver mustang notch with just a few bolt-ons and engine mods. Here's a quote from his page: "Last summer I installed one of the awesome INCON Twin Turbo kits. This is a very well thought-out and complete Street Turbo Kit. I did nearly the entire project by myself, in my garage, with no special tools. The full story is here. It is perfectly streetable, and saw about about 300 miles per week, including an 11 day, 4000 mile plus trip to race at the World Ford Challenge, Texas, and more - pulling a trailer!. How did it run? Last September, on a warm and muggy night at Va Motorsports park, it turned 11.00 @ 124.17 mph. Stock ported heads/intake, driven to and from the track. Not bad! With some better heads and intake, along with a bullet-proof AOD, it ran 10.92 @ 126 mph on ET Streets and through the mufflers. That was with a very lazy 1.68 60 ft." Oh, and he averaged around 24mpg on the highway. Here's his page: http://members.home.net/bobcosby/stang/ TDC (Turbo Driven Concepts) makes some other kits...and I know there are a couple of other manufacturers out there but they escape me for now. --nathan ------------------ --silver_pilate '91 GT, Built 306, Wolverine 1087 cam, ported Windsor Jr. Irons, and all the goodies...click the link to the left to see a full list of my mods... Tried and True 302 Being Built to Outrun You! heh heh heh... --Texas Panhandle-- Check out my site [This message has been edited by silver_pilate (edited 09-21-2001).]