Threaded Mode
© Copyright 2026 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-11-2005, 02:12 AM
|
#6 |
|
Registered Member
Join Date: Jun 2000
Location: ventura,CA
Posts: 438
|
Re: Cheap heads or "Cheap Heads"??
Well, I'm running ported 70' 351W castings with .190 160. valves. Anything I get will be better. I was just curious if anyone was using them. For $800, they're cheaper than World Products. Just going for 400 horses with a .030 over 351W block. It's either that or Ebay. I feel safer purchasing these than from a Seller on Ebay. Believe me, if I had the money to buy a super sweet set of heads I would. Just seeing if I could save a few bucks on the heads if other people had good feedback about them. Thanks!!
__________________
92 GT, 4:10 gears, centerforce clutch, 6# powerdyne blower, bbk h-pipe, flowmasters 65 Mustang 13.50 107mph 3000' ALt. 65 Falcon Straight Axle Drag Car |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| GT-40 heads | 5.0 Pony | Windsor Power | 1 | 09-10-2002 10:26 PM |
| val springs in stock 97 heads , quesion ? | southernstang97 | Modular Madness | 0 | 07-16-2002 11:52 AM |
| Help with heads, what to do???? | HiFlow5 0 | Windsor Power | 5 | 07-14-2002 06:22 AM |
| ??? about 351W heads on a 302 | vande97 | Windsor Power | 2 | 05-15-2002 10:42 AM |
| For whoever it was considering using stock ported heads | 2FastLX | Windsor Power | 5 | 10-11-2001 01:53 PM |