Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-20-2001, 02:53 PM
|
#9 |
|
Registered Member
Join Date: Mar 1999
Location: Sanford NC USA
Posts: 155
|
check that MAF sensor just a thought since everybody else was stabbin at it, it might be a lil dirty gets some electronics parts cleaner (sadvance auto) and clean the two lil wire elements but if it was that you would be getting a check engine light, same as O2's
------------------ SOLD THE 87GT, .. GT40, 70mmTB, 75mmBullet, 24lbinjectors, cold air induction, Edelbrok 6025 Rpm's, Inch phonolic spacer, tall FMSvalve covers, an SFI balancer, Canton 7quart, the shortblock... Lunati 51025 (224/232 .535/. 544 @112 deg) Ross lightweight pistons (10:1) Eagle H-Beams, Total Seal plasma Moly Rings, Clevite bearings, ARP throughout, FMS main Girdle&Studs, Forged Crank, of course HV-OilPump and hardened FMS shaft, Dual Friction centerforce, T5, and 4.10's Longtubes and 2.25 tail pi |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pulled codes...what do they mean? | Hethj7 | Windsor Power | 8 | 06-12-2003 12:03 PM |
| Pulled intake and swapped fuel rails now getting codes. | Rebel79 | Windsor Power | 3 | 09-03-2002 12:13 AM |
| pulled codes and could use some advice | Conman | Windsor Power | 9 | 08-17-2002 06:41 PM |
| Pulled codes today... | bobtodd | Windsor Power | 24 | 08-08-2002 07:55 PM |
| Ok, I pulled the codes, but what the heck do they mean | tireburner163 | Windsor Power | 18 | 12-02-2001 04:12 PM |