Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-23-2005, 05:54 AM
|
#7 |
|
Registered Member
Join Date: May 2002
Location: Tampa,FLORIDA
Posts: 340
|
Re: mind bender 5.0
I dont have any experience with the ECM, I just use MSD ignition on mine. Some one who has done this conversion over to mass air could probably chime in here.
But if the ECM is from a H.O. motor then it should work with the H.O. cam. (E cam is an H.O. cam). The heads dont really matter. Any heads will work. The lifters just follow the cam anyways.
__________________
5.0, Holley heads, 1.7 Scorp Rockers, Stealth intake, Holley 600 carb, Holley Mech. Fuel pump, MSD 6Digital, MSD distributor, Hotchkis upper/lower rear control arms, FMS B Springs, 3:73 (8.8) rear. Production # 9,377 |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| sorry never mind | fordkid68 | Classic Mustangs | 0 | 11-21-2002 08:04 PM |
| Hey turbo guys, make up my mind | 347powered | Windsor Power | 1 | 03-01-2002 08:50 PM |
| Im doing AOD to T-5 swap, any helpfull info / things to keep in mind would be great | zepherman | Windsor Power | 4 | 09-26-2001 01:21 PM |
| can not make up my mind need your help | joey50gt | Windsor Power | 3 | 05-01-2001 12:42 AM |
| Car starts and wont start, will it make up its mind? | 89FHPLX | Windsor Power | 5 | 01-14-2001 02:37 AM |