Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-26-2005, 11:41 AM
|
#5 |
|
Registered Member
Join Date: Feb 2003
Location: Washington
Posts: 33
|
Re: How long does it take moly rings to seat?
PKRWUD havent done the leak down yet with thanksgiving and all also taking a break from it before I set it on fire. Havent noticed any oil consumption probably cause I have done 3 oil changes in the 350 miles since the motor has run. I'm positive the rings are right side up. As long as the wife doesnt have something for me to do I will probably do the leak down today or tomorrow. thanks for the reply.
__________________
New 302 block, Probe forged pistons,Moly rings,I-beam rods,Main girdle,Canton 7Qt pan,B-cam, Edelbrock 6037's ported/decked,Exploder upper/lower ported,#24 inj,190lph fuel pump,70mm tb,73mm maf,MSD dist/coil,6al box,3.73's,Steeda lca's,QA1 k-member,subs,strut tower brace. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Seatbelt Laws... | StangFlyer | Blue Oval Lounge | 45 | 04-25-2021 04:06 PM |
| BBK long tubes on P heads | procharge94 | Windsor Power | 0 | 05-04-2005 03:05 AM |
| TFS High Ports and Long Tubes | HORSEMEN RACING | Windsor Power | 3 | 07-16-2002 12:57 PM |
| 1991 Back Seat Bracket??? | jz_mustang50 | Windsor Power | 0 | 10-07-2001 08:39 PM |
| BBK one-piece flange or MAC individual flange long tube headers. | Fox Body | Windsor Power | 10 | 04-03-2001 04:25 PM |