Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-13-2005, 03:18 PM
|
#3 |
|
Rat Killer
Join Date: Aug 2002
Location: Cold ass Ohio
Posts: 1,143
|
Re: What are stock pushrod length on a 5.0 motor
I thought the .272's were stock, but wasn't sure and waited for a second opinion. I also think you're close enought not to worry about it.
I forget the exact length I needed on mine, but noone made them. The one's in the motor are .005" SHORTER than I figured what I needed, and she's good to go, all the way up to 8,000!!!! Check into Trick-Flow push rods. NICE piece for the money, LOTS of my friends are running them, no probs so far. Go for it.
__________________
d-Con Racing "Nothing fancy, just 347 inches of RAT POISON!" MICE need not apply..... 
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| head/cam question for a stock shortblock motor | StockRustang | Windsor Power | 4 | 09-08-2005 08:26 PM |
| AFR 165 pushrod length question. | JaxMustang50 | Windsor Power | 2 | 04-13-2003 11:39 PM |
| Stock motor??? | 5.0L_Of_Fury | Blue Oval Lounge | 2 | 09-28-2002 12:37 AM |
| how fast have you guys gone with a stock motor | tireburner163 | Windsor Power | 39 | 01-16-2002 08:09 AM |
| E-303 Cam.. New install on stock motor. Do they really Idle bad?? | 89FHPLX | Windsor Power | 23 | 01-14-2002 09:00 PM |