Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
12-13-2005, 08:38 PM
|
#1 |
|
Registered Member
Join Date: Jul 2000
Location: Rochester
Posts: 323
|
Re: What are stock pushrod length on a 5.0 motor
85-96 5.0s are 6.272"
79-85 5.0s are 6.904" Comp cams has a set that's 6.250" for roller cams and 6.876" for flat tappet cams. Be carefull, if you go too big a pushrod you mess up the whole geometry and the valves will not fully close. Hope this helps....
__________________
95 GT convertable, ported+polished GT40 heads, port matched upper and lower Cobra intake manifold, Flowthech headers, Catco hi-flow h-pipe with 2 hi-flow cats, Mac true fit catback exhaust, 3.73 gears, underdrive pullies, Edelbrock 70mm throttle body, Mac cold air intake, FMS 24lb injectors, Granatelli 75mm mass air |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| head/cam question for a stock shortblock motor | StockRustang | Windsor Power | 4 | 09-08-2005 08:26 PM |
| AFR 165 pushrod length question. | JaxMustang50 | Windsor Power | 2 | 04-13-2003 11:39 PM |
| Stock motor??? | 5.0L_Of_Fury | Blue Oval Lounge | 2 | 09-28-2002 12:37 AM |
| how fast have you guys gone with a stock motor | tireburner163 | Windsor Power | 39 | 01-16-2002 08:09 AM |
| E-303 Cam.. New install on stock motor. Do they really Idle bad?? | 89FHPLX | Windsor Power | 23 | 01-14-2002 09:00 PM |