Im doing AOD to T-5 swap, any helpfull info / things to keep in mind would be great

fiveohpatrol · 09-25-2001, 01:37 PM

this this site out http://members.aol.com/black306/AODT5.html

i did the swap a few months back and that site helped me out tremendously, especially the parts list so you can get everything together beforehand, i was able to re-use the AOD crossmember without modifying it, also dont blow off getting that harness for the back up lights and neutral safety switch otherwise your car wont start when you get done

NewAge5.0 is right about the pedals, they are a pain in the A$$ but if you take your time its not extrememly horrible, i'd rather change a heater core than do pedals again though

just follow the instructions on that site and you'll be fine, it is very complete

------------------
88 Notch, B&M Ripper, 3.73's, Ported E7's, Explorer int. w/ ported lower, pulleys, 1.7RR's, BBK headers, off-road H-pipe, flowmasters, subframes, 65mm TB, March ram air ,MSD coil, U/L control arms, 155lph f/p, Crane Adj.FPR, Nitto drag radials, best 1/4--> 13.76@101.4 on a 2.17 60ft

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Carb swap info	RoushRacing6N17	Windsor Power	2	02-13-2004 01:07 PM
Gear Swap Info	oneba87lx	Windsor Power	15	09-10-2002 10:35 AM
carb swap info	flyin 5.8	Windsor Power	1	08-06-2002 07:31 PM
Need some 351 swap info.	fastang	Windsor Power	4	02-05-2002 11:10 AM

09-25-2001, 01:37 PM	#3
fiveohpatrol I'd rather be basketweaving Join Date: Feb 2000 Location: Indianapolis Posts: 2,551	this this site out http://members.aol.com/black306/AODT5.html i did the swap a few months back and that site helped me out tremendously, especially the parts list so you can get everything together beforehand, i was able to re-use the AOD crossmember without modifying it, also dont blow off getting that harness for the back up lights and neutral safety switch otherwise your car wont start when you get done NewAge5.0 is right about the pedals, they are a pain in the A$$ but if you take your time its not extrememly horrible, i'd rather change a heater core than do pedals again though just follow the instructions on that site and you'll be fine, it is very complete ------------------ 88 Notch, B&M Ripper, 3.73's, Ported E7's, Explorer int. w/ ported lower, pulleys, 1.7RR's, BBK headers, off-road H-pipe, flowmasters, subframes, 65mm TB, March ram air ,MSD coil, U/L control arms, 155lph f/p, Crane Adj.FPR, Nitto drag radials, best 1/4--> 13.76@101.4 on a 2.17 60ft