Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-12-2006, 02:06 PM
|
#11 |
|
Registered Member
Join Date: Mar 2004
Location: Minnesota
Posts: 950
|
Re: Rear axle and bearing change instructions
When I got my 8inch out of the junkyard, I had to replace one of the bearings. A pain in the ass, but not too bad I didnt think. When I went to remove the axle Im too poor for the right tools, so I used a chain hooked to the axle and a C-clamp attached to the chain for a handle. Alot of hard pulls later it poped out. I got the bearing pressed on by a shop though.
__________________
Alex |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rear end noise - axle bearing? | mpj76 | Windsor Power | 5 | 07-13-2005 12:25 PM |
| Bear rear axle + C Clip eliminator...@#$%#$ | eatsgmcar | Windsor Power | 4 | 09-24-2002 01:48 AM |
| Axle bearing removal | moc | Windsor Power | 0 | 07-18-2002 12:03 AM |
| Rear Axle Removal | diablopony | Classic Mustangs | 14 | 05-21-2001 07:23 PM |