help pleeze.... running like sh't, now won't start (long)

PKRWUD · 09-27-2001, 06:12 AM

Ignition flowchart:
Using a home made test light (use any auto bulb, like a turn signal bulb, and attach two wires), check for voltage at the coil with the key on.
None: check the ign. switch.
Voltage: ground a spark plug attached to a plug wire attached to coil & crank engine.

No spark: replace coil.
Spark: repeat with plug attached to plug wire w/ all wires attached to cap.

Spark: verify firing order and relationship between cap and rotor.
No spark: try different wire.

Spark: replace plug wires.
No spark: check distributor cap and rotor.

As far as your carb gasket goes, clean off the silicone and check the throttle plate and manifold with a straight edge. Use a new gasket. Never apply silicone to a carb base gasket. Verify the float level and your fuel pressure.

With these things set, it should run. Once it's running, set the idle mixture and idle speed. Use a vacuum gauge for this.

Take care
~Chris

------------------
Retired Moderator
MustangNet

My site: JimPorterRacing

RACECAR spelled backwards is RACECAR

HEY !!! Are you ASE Certified ??? If you are, ask me about iATN. The best tool you'll ever have, and it's free !!!

[This message has been edited by PKRWUD (edited 09-27-2001).]

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
A Crazy Weekend for the books (Long)	Mercury	Blue Oval Lounge	9	11-05-2002 12:23 AM
Car's running hot...	Sonics2042	Windsor Power	8	07-16-2002 04:50 PM
URGENT!!car won't start (quite long)	HKstang	Windsor Power	7	04-08-2001 01:40 PM
PLEASE HELP! 97 Cobra won't start.	cobrayankee	Modular Madness	5	01-18-2001 04:53 PM

09-27-2001, 06:12 AM	#3
PKRWUD Junior Member Join Date: Mar 1999 Location: Ventura, California Posts: 8,981	Ignition flowchart: Using a home made test light (use any auto bulb, like a turn signal bulb, and attach two wires), check for voltage at the coil with the key on. None: check the ign. switch. Voltage: ground a spark plug attached to a plug wire attached to coil & crank engine. No spark: replace coil. Spark: repeat with plug attached to plug wire w/ all wires attached to cap. Spark: verify firing order and relationship between cap and rotor. No spark: try different wire. Spark: replace plug wires. No spark: check distributor cap and rotor. As far as your carb gasket goes, clean off the silicone and check the throttle plate and manifold with a straight edge. Use a new gasket. Never apply silicone to a carb base gasket. Verify the float level and your fuel pressure. With these things set, it should run. Once it's running, set the idle mixture and idle speed. Use a vacuum gauge for this. Take care ~Chris ------------------ Retired Moderator MustangNet My site: JimPorterRacing RACECAR spelled backwards is RACECAR HEY !!! Are you ASE Certified ??? If you are, ask me about iATN. The best tool you'll ever have, and it's free !!! [This message has been edited by PKRWUD (edited 09-27-2001).]