Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-26-2001, 09:52 PM
|
#2 |
|
Registered Member
Join Date: Apr 2000
Location: middleburg, fl, usa
Posts: 1,134
|
You should see a little improvement with it and if it is extrude honed it will outflow the gt-40 but not by much. The great thing about it is you will have an intake that looks stock but flows like an expensive intake. The extrude honed intake will also have a better runner balance than most after market intakes.
It will make a bigger improvement when you get some heads. I would get gt-40 heads if you’re on a budget, you can usually find them for around 400 dollars used. ------------------ James Cox nochevy@hotmail.com 1991 Mustang LX No good times with 347 stroker yet! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| GT40 vs Stock lower intake difference | ca_mustang | Windsor Power | 3 | 03-02-2004 05:03 PM |
| Port match stock intake? | skiwesser | Windsor Power | 3 | 11-21-2002 02:09 AM |
| ported stock intake and heads | explicitone | Windsor Power | 0 | 04-18-2002 06:22 PM |
| TFS intake and stock throttle body?? | DemonGT | Windsor Power | 2 | 05-23-2001 01:19 PM |
| Trophy Stock Intake Question? | RL Wiltshire | Racer's Club House | 7 | 10-20-1999 08:11 PM |