

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
![]() |
#1 |
Registered Member
Join Date: Sep 1998
Location: Oviedo, FL
Posts: 992
|
![]() Most cars look good in pictures and from 50 feet. As said above RUST will be your biggest concern. The typical rust places on Mustangs go through to the 67-68-etc.
Frame rails, torque boxes, fender aprons, cowl, trunk floor, passenger compartment floors, inner and outer rear fender wells, rear quarters, bottom of the doors, bottom of the front fenders. Did I leave any sheet metal out?? Also....as said above, be careful if you see undercoated sprayed all over. It may be covering up lots of sins. Lastly...the engine is the least of your worries. If you're not comfortable checking the body/frame over, hire a professional to look at it. You'll save money in the long run. 10K US isn't bad....IF and that's a BIG IF....it isn't a "rust bucket".
__________________
"Support our Troops" Dave 1968 Cougar 2004 Thunderbird 2007 F150 Harley-Davidson, SuperCrew 1986 LTD 1997 Ranger 1992 Honda Civic |
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
eibach advice needed | mustardjohn | Small Ponies | 6 | 08-19-2012 08:12 PM |
87 Coupe with Turbo Coupe Disc Rear | ca_mustang | Windsor Power | 1 | 01-31-2004 05:57 PM |
90 coupe or 90 GT? | HopingForAGT | Windsor Power | 11 | 03-03-2002 02:06 AM |
'69 Mach 1 or Coupe???? | 6T9PONY | Blue Oval Lounge | 4 | 08-15-2001 12:25 PM |
Need stall converter advice | Rev | Classic Mustangs | 9 | 04-19-2000 10:55 AM |