MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Classic Mustangs
Register FAQ Members List Calendar

Notices


 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
Old 04-26-2006, 08:03 PM   #7
Rev
Registered Member
 
Rev's Avatar
 
Join Date: Nov 1998
Location: Houston, Tx.
Posts: 3,887
Default Re: no third gear problem--help

That's the detent linkage. It causes a downshift when you floor rhe accelerator. It shouldn't have anything to do with the 2-3 upshift. I had a similar problem once. It was a stuck valve in the valve body. You can take that out yourself, disassemble , and check for the stuck valve. That's what I did and was able to free up the valve myself and restore proper shifting. I recommend getting the Ford shop manual if you attempt the fix yourself. You can do that without removing the trans from the car. Good luck on it. Any trans shop should be able to clean up the valve body for not too much $$$ I would think, but then they might also try to make you go for a complete rebuild.

Rev
__________________
'66 Coupe, 306, 350-375 HP, C-4, 13.07 e.t., 104.8 mph, 1/4 mi.

O.B.C. #2


'66 coupe

Last edited by Rev; 04-26-2006 at 08:46 PM..
Rev is offline   Reply With Quote
 



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Speedo Gear Question Harry Windsor Power 21 08-22-2002 03:28 PM
speedo gear redrider Windsor Power 1 01-17-2002 10:06 PM
Distributor gear.... is it steel? DRASTiK Windsor Power 5 01-09-2002 12:37 AM
Rapid distributor gear wear on roller cam 351 fxbill Windsor Power 5 01-08-2002 02:56 PM
Surging Problem - Help Lawless Windsor Power 32 08-19-2001 10:57 PM


All times are GMT -5. The time now is 05:08 AM.


SEARCH