Threaded Mode
© Copyright 2026 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-16-2006, 10:13 PM
|
#27 |
|
Registered Member
Join Date: Dec 2004
Location: South Central PA
Posts: 358
|
Re: dual pattern cams
I've had a rocker arm stud pull out as well on a set of 68 302 2v heads... my solution was to tape off everything around the hole where the stud was and I tapped out the hole for a screw in stud and was real careful cleaning up the mess of tap shavings. Worked great and never had to even pull off the head.
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| need help measuring torque converter bolt pattern | 82 GT | Windsor Power | 0 | 06-17-2003 03:38 PM |
| Dual vs. Single Pattern Cam | jimmyjamed | Windsor Power | 2 | 02-09-2003 10:20 PM |
| Dual confusion | sjlawr | Small Ponies | 8 | 11-25-2002 02:02 PM |
| how can you tell apart 99 heads and cams and 98 heads and cams | 98 NosStang | Modular Madness | 5 | 09-25-2001 11:51 PM |
| Question concerning HEADS and CAMS...... | QuickSilver96 | Modular Madness | 0 | 12-12-1999 02:16 AM |